Additional Information

ND-54 Tube End Notcher

Pipe material: Aluminum, Copper, Copper / Nickel
Machine type: Portable tools
Process: End forming

Most commonly used in:

ND-54 Tube End Notcher

T-DRILL ND-54 Tube End Notcher is used for cutting and dimpling the branched tube ends to enable the best possible flow characteristics.

The ND-54 is a natural complement to the T-DRILL tee forming system. It cuts a half-moon shaped coupon from each side of the branch tube to provide for full flow and simultaneously presses in a dimple that rests on the rim of the tee that acts as a depth stop. A second dimple 6 mm higher acts as a point of inspection. The result is an inspectable brazed joint with the best possible flow characteristics.

For branch tube sizes 12, 14-16, 18, 22, 28, 35, 42 & 54 mm and corresponding inch sizes: ½”, ¾”, 1”, 1 ¼”, 1 ½” & 2”.

T-DRILL ND-54 Tube End Notcher hand

T-DRILL ND-54 Tube End Notcher with copper tube

Feel free to ask for more information:

    Address

    Country

    Business Sector

    HVAC

    HVACHeating, Air Conditioning, VentilationRefrigerationWater HeatingSolar Panels

    Automotive

    Engine CoolingExhaust (Exhaust Circulation, Muffler, sensors)Brake and FuelAir ConditioningPower Steering

    Shipbuilding

    Naval ShipyardCivilian and Cargo ShipyardRepair Shipyard

    Stainless Steel Enterprises

    Water Treatment Food, Dairy and BreweryPharmaceutical and Chemical IndustryLiquid Level and Flow MeasurementWater Pumps/Boosters, Circulation

    Plumbing and Mechanical Contractors

    Plumbing and Mechanical Contractors

    Other

    Position in the Company

    Department

    Message

    Upload a file


    approved By submitting this form, I accept privacy policy


    Share on social media

    Contact us