T-115 & Tube Measuring Table

Additional Information

General
Technical Information
You might also need
Ask for more information

T-115 & Tube Measuring Table

Pipe material: Aluminium, Carbon steel, Stainless steel, Steel
Machine type: Industrial machines
Process: Collaring

Most commonly used in:

Product material:

Brochure Collaring Machine T-115 EN

T-115 Collaring Machine & Tube Measuring Table

T-DRILL T-115 measuring table is used for controlled and precisely dimensioned transfers of pipes in the angle and axial directions. Using the measuring table it is possible to estimate accurately both the distance as well as the angle gap between two collars (or the start-off point and the collar). The measuring table is suitable for pipe sizes Ø33,7–323,9 mm. The maximum length of the pipe is 3000 or 6000 mm.

THERE ARE TWO STANDARD LENGTHS AVAILABLE: For tube length 3000 mm and 6000 mm.

Tube Measuring Table 3000

Manual Measuring system for run-tube
For diameters Ø33,7–323,9 mm and lengths min. 3 x O.D. and max 3000 mm
(When working with small diameters, please contact T-DRILL Sales to ensure the l min measurement)
Positioning tolerances:
- length +/- 0.5 mm (machine); +/- 1.0 mm (tube)
- angle +/- 0.5º (machine); +/- 1.0º (tube)
Longitudinal and angle position can be seen from digital read-out

Tube Measuring Table 6000

Manual Measuring system for run-tube
For diameters Ø33,7–323,9 mm and lengths min. 3 x O.D. and max 3000 mm
(When working with small diameters, please contact T-DRILL Sales to ensure the l min measurement)
Positioning tolerances:
- length +/- 0.5 mm (machine); +/- 1.0 mm (tube)
- angle +/- 0.5º (machine); +/- 1.0º (tube)
Longitudinal and angle position can be seen from digital read-out

COMPARISON: Welded Fittings vs T-DRILL Collaring & Flanging

Please accept marketing-cookies to watch this video.

You might also need:

TEC-220 Collaring Machine

SEC-115 Fully Automatic Collaring Machine