Most commonly used in:
Hand Feed Table (HFT) basic unit can be equipped also with a pneumatic operated Internal Punching Unit (IPC), for producing 6, 8, 10 or 12 mm “IPC-collars” with fixed tooling.
IPC module can be equipped as a “stand-alone” solution with Hand Feed Table and it will utilize mechanics from the table including two axial templates for different manifold set-up. IPC unit requires always tooling for specific size.
In case that also T-DRILL T-35 or T-65 unit is placed in the same table, both solutions will work parallel at the system benefiting the most optimal collar. In case some special collar size is required, T-DRILL unit can be adjusted in a few minutes to perform required size.
Fields marked with * are mandatory.